Cannot see http and stream

Questions? Suggestions? Need help? Talk about anything related to Yawcam...
Post Reply
qtpham81
Posts: 2
Joined: Mon Sep 21, 2009 12:40 pm

Cannot see http and stream

Post by qtpham81 »

Hi All,

It quite strange. When I change my router from Thomson Speedtouch to Prolink WR1004, then I cannot see http and stream any more! Previously everything fine.

Now, even I cannot see the http/stream when using http://locahost:8888 and http://localhost:8081. The browse runs and waits indefinitely and no response. However, Yawcam is able to capture motions and send email to my Hotmail account.

My console shows:

[17:20] Yawcam started
[17:20] Settings loaded
[17:20] Language: English
[17:24] Http-output started
[17:24] Stream-output started
[17:27] UPNP: Found device AboCom Systems, Inc. UPnP Gateway Device IGD Version 0.92
[17:27] UPNP: Found device AboCom Systems, Inc. UPnP Gateway Device IGD Version 0.92

Any idea?

TIA
qtpham81
Posts: 2
Joined: Mon Sep 21, 2009 12:40 pm

Post by qtpham81 »

Further investigation, I found that if I disconnect my PC to the router, then re-start YAWCAM, I can see http/stream using my local IP (127.0.0.1).

If I reconnect my PC to the router, then re-start YAWCAM, the same problem happens - I cannot see neither the http page nor stream. No error in the browser but it was loading .... forever!

Any idea?
tellmewhy
Posts: 425
Joined: Tue Dec 11, 2007 11:19 am

Post by tellmewhy »

I googled a bit on the topic.
See here some info about the IP : 127.0.0.1.
It's the loop-back IP of the machine you are working on.

Are you certain the machine in question can connect to the internet ?
Are you sure there is no hardware problem with the network adapter ?
Can you open a command prompt and execute "pcconfig /all" ?
One of the info you will see are :

Code: Select all

Ethernet adapter Local Area Connection:

        IP Address. . . . . . . . . . . . : 
        Subnet Mask . . . . . . . . . . . : 
        Default Gateway . . . . . . . . . : 
What does that show ?
Post Reply