Delayed

Questions? Suggestions? Need help? Talk about anything related to Yawcam...
Post Reply
Elgringo
Posts: 1
Joined: Sat Sep 22, 2012 10:11 am

Delayed

Post by Elgringo »

I have a logitech quickcam fusion and dump each 30seconds an image. This image is only actual when I have the preview screen shown. If not it has a hughe delay (few seconds).

What's the cause of it, and how can I solve it.

If I run it as a service it has the same delay.
memoric
Posts: 184
Joined: Wed Feb 23, 2011 1:37 pm

Post by memoric »

Can't really say, but it sounds like it takes some time for the camera to initialize.
Try turning the motion detection on with all its actions turned off & set sensitivity
to 0% & tolerance to 100% (so it never triggers). That should keep the camera
"awake" & eliminate the delay.
Post Reply