Help. Can't Get My Stream or HTTP Online.
Posted: Sat Oct 20, 2012 10:03 pm
From the Yamcam "Control Panel".
I go to "Settings"
Which brings up the "Edit>Sttings" window. I then go to the "Connection" tab
I click on the "GET" button and my local IP is set.
Then I go to my "Stream" tab and click on it to set the port to 8081
I go back to the "Connection" tab
and click the "Am I Online" buttom.... and I get this...
Both http and stream is enabled
So I go to my Router/Modem and make sure the UPnP is enabled, it is
After checking I find I am still not Online. So I go to port forwarding and I forward ports
In the above pic and in my Router/modem it doesn't say to put in a IP address, but it won't accept the forwarding without one so I put in the LAN (?) network address a couple of different ways.
I recheck and I am still not online according to the "Am I Online" check in the Control Panel> settings >connection window.
So now I disable all my virus protections and go to my windows based firewall and allow Yamcam
I go back to the "Am I Online" check in the Control Panel> settings >connection window.
and I still get this...
Any suggestions?
I go to "Settings"
Which brings up the "Edit>Sttings" window. I then go to the "Connection" tab
I click on the "GET" button and my local IP is set.
Then I go to my "Stream" tab and click on it to set the port to 8081
I go back to the "Connection" tab
and click the "Am I Online" buttom.... and I get this...
Both http and stream is enabled
So I go to my Router/Modem and make sure the UPnP is enabled, it is
After checking I find I am still not Online. So I go to port forwarding and I forward ports
In the above pic and in my Router/modem it doesn't say to put in a IP address, but it won't accept the forwarding without one so I put in the LAN (?) network address a couple of different ways.
I recheck and I am still not online according to the "Am I Online" check in the Control Panel> settings >connection window.
So now I disable all my virus protections and go to my windows based firewall and allow Yamcam
I go back to the "Am I Online" check in the Control Panel> settings >connection window.
and I still get this...
Any suggestions?