Hello,
I'd like to use two instances of yawcam each using a different camera: the one will use the BI - built-in cam and the second, an external USB attached webcam. I noticed that the second instance will always use the same setting as the first and will complain in case of conflict such as port #. If it were for ports only, i could reenter them upon every launch but this becomes an issue if i wanted many settings such as motion actions and actions settings to be per camera. My question is if there is a simple mean to direct each instance to a given setting even with a command line such as "yawcam -s settingFile -c camera"
Thanks in advance for your time
Guy
setting for a second instance (2 cam system)
-
- Moderator
- Posts: 1210
- Joined: Wed Jan 14, 2009 3:50 am
Re: setting for a second instance (2 cam system)
Follow the instructions here: http://www.yawcam.com/forum/viewtopic.php?p=140#p140
Re: setting for a second instance (2 cam system)
Thanks, Everything work as described
Curiously, the first instance will always start with preview on, even if unchecked but this is not annoying.
Is there a way that the program(s) start with buttons pressed as set by the operator; e.g motion and stream on the rest off?
Thanks again for your help
Curiously, the first instance will always start with preview on, even if unchecked but this is not annoying.
Is there a way that the program(s) start with buttons pressed as set by the operator; e.g motion and stream on the rest off?
Thanks again for your help
-
- Moderator
- Posts: 1210
- Joined: Wed Jan 14, 2009 3:50 am
Re: setting for a second instance (2 cam system)
To get rid of the preview in the first instance, you can set the "Service" keyword to it aswell. The steps are outlined in the link above.
As for the startup settings, you can go in the settings, there is a Startup section where you can select what starts on startup, including the preview.
As for the startup settings, you can go in the settings, there is a Startup section where you can select what starts on startup, including the preview.
Re: setting for a second instance (2 cam system)
I am sorry, but i could not find the startup section in .yawcam directory of either program copies.z3r0c00l12 wrote:...
As for the startup settings, you can go in the settings, there is a Startup section where you can select what starts on startup, including the preview.
Below the items found in .yawcam of the first program
banlist.dat
disablerunningcheck.txt
extravars
img
logs
motion
pass.dat
stream
tmp
ver.dat
www
yawcam_settings.xml
here for the second copy .yawcam content
banlist.dat
disablerunningcheck.txt
extravars
img
logs
motion
pass.dat
stream
tmp
ver.dat
www
yawcam_settings.xml
-
- Posts: 50
- Joined: Mon Apr 18, 2011 7:40 pm
Re: setting for a second instance (2 cam system)
The startup section is in the drop down menu under "Settings", "Edit Settings", and then select "Startup". This will present you with a list of check boxes to set up as default.
Re: setting for a second instance (2 cam system)
Sorry, stupid question