Hi
I am trying to connect my ip camera to yawcam. The camera is Wansview-625W and the video output
is H.264.
But all i get is Error: Could not connect to the device. I have tested this site for my ip camera URL : http://www.ispyconnect.com/man.aspx?n=wansview
but nothing works.
Does Yawcam not support H.264?
what are my possibilities !
best regards
jon
can´t connect ip camera Wansview NCM-625W
-
- Posts: 57
- Joined: Mon Dec 29, 2008 6:24 pm
Re: can´t connect ip camera Wansview NCM-625W
No, Yawcam will not work with H264 compression but it will with M-JPEG and it looks like your camera does have the option of M-JPEG streaming (see http://www.wansview.com/all-cameras/708-ncm-625w and look on the Specifications tab). There should be an option to change the stream output type
Re: can´t connect ip camera Wansview NCM-625W
Hi and thanks!
I did not find the mjpeg url stream from my camera. Even though i ran ISPY and found a lot of urls... every one of them didn´t
work with yawcam.
But then I installed IP Camera [JPEG/MJPEG] v.5.8.0.0 ....and voila! yawcam could connect to my ip camera. IP Camera v.5.8.0.0
provides a good properties window.
best regards
jon
I did not find the mjpeg url stream from my camera. Even though i ran ISPY and found a lot of urls... every one of them didn´t
work with yawcam.
But then I installed IP Camera [JPEG/MJPEG] v.5.8.0.0 ....and voila! yawcam could connect to my ip camera. IP Camera v.5.8.0.0
provides a good properties window.
best regards
jon