Hi,
I have used YAWCAM previously and used YAWViewer to view the Cam on another PC. This worked well.
I have just installed it to start using it again, and am using the latest version, but YAWViewer will not connect for some reason, just get a Red X in the top left.
I have enabled 'Stream' and if i go to the browser and type IP:PORT it shows up in the browser OK.
Is there anything special i need to do for it to work in YAWViewer or is there another similar program out that allows you to have it on top of other things, and not in a browser?
Thanks
CoZZa
Viewer
Yawviewer v1.2.3 doesn't work with Yawcam v0.3.0?
Hi CoZZa,
Apparently, Yawviewer v1.2.3 doesn't work with the latest version of Yawcam.
I've started looking into the reasons.
I will notify the forum if a new version of Yawviewer is released.
Thanks for your interest and patience,
Jesse
Apparently, Yawviewer v1.2.3 doesn't work with the latest version of Yawcam.
I've started looking into the reasons.
I will notify the forum if a new version of Yawviewer is released.
Thanks for your interest and patience,
Jesse
New version of Yawviewer available!
Good news, CoZZa!
A version of Yawviewer that works with Yawcam v0.3.0 is now available!
http://www.yawcam.com/forum/viewtopic.php?p=2135#2135
A version of Yawviewer that works with Yawcam v0.3.0 is now available!
http://www.yawcam.com/forum/viewtopic.php?p=2135#2135