Loses camera since software upgrade
Loses camera since software upgrade
Since upgrading to the latest software a week ago, after a few minutes running the preview says "no device selected". Restarting Yawcam gets it going again for a little while. With motion capture running this is pretty useless as it too blanks after a few minutes.
It's possible that the power settings for you USB device is causing the problems. Please read more about this in this post:
http://www.yawcam.com/forum/viewtopic.php?p=4258#4258
/malun
http://www.yawcam.com/forum/viewtopic.php?p=4258#4258
/malun