HI, I recently installed Yawcam on my Windows 10 PC. I can preview my Logitech Brio webcam fine from my PC and have enabled Streaming in Yawcam.
However, when I try to add an IP Camera in Synology and look for the Webcam SSS can't find it.
Any suggestions on what the problem might be?
Setup PC Webcam with Synology Surveillance Station
Re: Setup PC Webcam with Synology Surveillance Station
Change Yawcam to stream as MJPEG:
Click:
"Settings -> Edit Settings... -> Stream -> Stream type"
and set it to "MJPEG".
Then let your Synology point to the URL http://ip-address:port/video.mjpg
You find your IP and port number by clicking:
"Help -> What's my URL?"
/malun
Click:
"Settings -> Edit Settings... -> Stream -> Stream type"
and set it to "MJPEG".
Then let your Synology point to the URL http://ip-address:port/video.mjpg
You find your IP and port number by clicking:
"Help -> What's my URL?"
/malun
-
- Posts: 1
- Joined: Sat Feb 24, 2024 1:50 am
Re: Setup PC Webcam with Synology Surveillance Station
when i do this it says on status authenticate but what that means i can,t authenticate what should i do
Re: Setup PC Webcam with Synology Surveillance Station
Make sure that you don't activate password protection in Yawcam and see if that helps.
https://www.yawcam.com/help/help_set_pass.php
/malun
https://www.yawcam.com/help/help_set_pass.php
/malun