can´t connect ip camera Wansview NCM-625W

[zetor]

Hi

I am trying to connect my ip camera to yawcam. The camera is Wansview-625W and the video output
is H.264.

But all i get is Error: Could not connect to the device. I have tested this site for my ip camera URL : http://www.ispyconnect.com/man.aspx?n=wansview
but nothing works.

Does Yawcam not support H.264?

what are my possibilities !

best regards
jon

[theoldschool]

No, Yawcam will not work with H264 compression but it will with M-JPEG and it looks like your camera does have the option of M-JPEG streaming (see http://www.wansview.com/all-cameras/708-ncm-625w and look on the Specifications tab). There should be an option to change the stream output type

[zetor]

Hi and thanks!

I did not find the mjpeg url stream from my camera. Even though i ran ISPY and found a lot of urls... every one of them didn´t
work with yawcam.
But then I installed IP Camera [JPEG/MJPEG] v.5.8.0.0 ....and voila! yawcam could connect to my ip camera. IP Camera v.5.8.0.0
provides a good properties window.

best regards

jon