Yawcam

well... I don't like to use anymore splitcam, it's offer more than we need with yawcam, so. in my case, when I use (for example) messenger, it says "your webcam is using by another program" (yawcam) well. how I don't want to use anymore splitcam, I'm building my own program in vb6, when you open it, this close automatly yawcam (killing) and when you close it (my program named webcamdriver 1.0) it runs yawcam again, so, you can use your webcam as normaly, only if my program is open.

my only problem with this is if you are using the webcam (with messenger or another program) and close my program (webcamdriver 1.0) this will open yawcam, and yawcam will send a message "can't to connect to device" and then this open the web cam setting.

so, if one of you knows how can i fix it this, I'll give you thanks!

I'm talking about someting like

if -device is busy-
-show alert before open again yawcam and close this program
else
-close this program and run yawcam
endinf

I'm using yawcam as service, healt and hide, thanks a lot!

yawcam is the best!

( watch this link if you want to try it, obiously it's all free )
http://www.visualvoz.com/webcamdriver 1.0.rar