Yawcam

everything worked fine yesterday upon first use. Today I can't get motion to stay selected. All Control Panel settings show RED stop signs and will not show anything else? On Motion window, I click Enable. It takes a photo and then reverts back to disabled. what is causing the motion detection to fail to stay engaged?

TIA
Peter
PS: after more poking around, i found it was the scheduler that was preventing anything from being selected. it might be a good idea to make note to new users that this setting is critical to successful operation. all is well now.

Isn't it obvious that if you enable scheduler everything that is supposed to be
off at a given time, will be off? That's why scheduler is disabled by default...