Page 1 of 1

Problems when trying to access IP cams

Posted: Wed Jun 19, 2019 7:49 pm
first of all thx for this nice SW - I am currently testing some features...

I mentioned an issue when trying to connect to an IP cam of my network (computer cam was OK).
As I have only 2 cams forr testing I do not know it is linked to the cam or the your program.
My cams are both from DB Power (VA038K and HD024P).
I can access them by the browser but cannot set it up in Yawcam.
Are those cams not supported? (I am not expert but both have an IP adress and should be ipcams?)

Thx for your reply