Page 1 of 1

Camera-settings gone after restart (UVC-Camera)

Posted: Mon Feb 15, 2021 4:27 pm
by Phil
Hi,

I´m using Yawcam under Windows 10 with a Logitech C920-C, which is installed with the Windows-internal UVC-driver. There are no special drivers for this camera from Logitech, since it is a special edition for plug & play.

My problem is, that the settings under settings -> device -> device properties are not saved in Windows, so when I restart Windows the settings I configured (e.g. manual autofocus) are reset to the default.

I think its a problem regarding Windows, but I can´t find a solution for this.

Maybe someone had this problem in the past and found a solution for this? Otherwise, I have to set these settings manually after each restart - but normally, I would like to restart the device every morning.

Thanks in advance & greetings from Germany!

Philip