Questions? Suggestions? Need help? Talk about anything related to Yawcam...
3 posts • Page 1 of 1
How do I make it alert only on actual motion but not when lights are being turned on/off? There must be away to configure it to detect actual motion only instead of a single change in the image which is not motion but lights going on or off. I've been experimenting but no luck so far.
I've tried many configuration "tweeks" and I still get emails/txts sent even when there is no motion at all, including in the middle of the night, pitch black. I've had to turn on "flood control" , set at 600 seconds (10 minutes) in the email settings so I don't get so many emails/txts. Maybe the developer can advise on the best settings for motion detection alerts.
Max filter - Motion events will not be triggered if the amount of motion is more than this percent. This is good to avoid a motion event when a change in light condition (or camera exposure) results in that almost all pixels in the image change at the same time.